CMT 855.803.11 3-Piece Glass Panel Set, 1/2-Inch Shank

The included 1/2-shank bits also make a square rabbet on the inside of your door for installing the glass panel. Not for use on hand-held router. After a test performed by Wood Magazine, CMT orange bits have been rated the first overall router bits compared to other brands. Included in the hardwood case you will find a Ogee Rail & Stile Set and a 1/8-Inch Slot cutter. From the Manufacturer Another innovative CMT product designed by Marc Sommerfeld. This unique stile and rail set allows you to easily produce glass panel doors utilizing a rubber panel retainer to secure the glass in an 1/8 slot that is cut into the door frames. This set works the same as our other stile and rail sets but leaves you with a square rabbet on the inside of your door for installing the glass panel. After machining the cope and pattern cuts use the 1/8 slot cutter to cut the groove for the rubber panel retainer. The edge of the pattern cut will ride on the guide bearing on the slot cutter bit (see drawing). When you cut the groove in the rails you can cut the slot the full length of the stock. When you cut the groove in the stiles you need to set up reference points to stop and start the cuts so they are hidden from view on the top and bottom of the doors. 1/2 Shanks. Make a square rabbet on the inside of your door for installing the glass panel 2 SinterHip Hi-Density Industrial Chrome Carbide cutting edges for long-lasting performance